FAG
New05644
ROTATION AXIS "C AXIS":
-Diameter of rotary table 200 mm
-Max load capacity 500 N
-Max control diameter 300 mm, se il tastatore è posizionato al di sopra del pezzo
-Max passage diameter 420 mm
-Air bearing
-Roundness deviation (sensing direction axisl, measured acc. to ISO 1101) 0.08 ųm at the centre + 0.0008 ųm per mm measuring height
-Roundness deviation (sensing direction axial measured acc. to ISO 1101) 0.08 ųm at the centre + 0.0008 ųm per mm radius
-Drive: position controlled direct-current motor
-Resolution angle measuring system 0.045°
-Measuring speed 1.5/3/6/12 min¯¹, variable
-Centering range +/- 2.5 mm
-Levelling range +/- 30'
-Tilting point 30 mm above table surface
VERTICAL AXIS "AXIS Z":
-Measuring distance 350 mm
-Straightness deviation (acc. to ISO 1101) 0.25 ųm/100 mm - 0.8 ųm/350 mm
-Air bearing
-Position controlled direct-current motor
-Resolution distance measuring system 1 ųm
-Measuring speed 15,60,300 mm/min, variable, optimal
-Moving speed 18 mm/s continuously adjustable by hand lever
-Rectangularity relative to C axis:
0.5 ųm/350 mm in sensing direction
2.5 ųm/350 mm at an angle of 90° off the sensing direction
HORIZONTAL AXIS "R AXIS":
-Measuring distance 150 mm
-Straightness deviation (measured acc. to ISO 1101) 1.0 ųm/150 mm
-Slide bearing
-position controlled direct-current motor
-Distance measuring system 1 ųm resolution
-Measuring speed variable
-Moving speed 25 mm/s continuously adjustable by hand lever
-Rectangularity relative to C axis''
SENSING SYSTEM ST200:
-Inductive sensing system
-Sensing direction bidirectional (no manual switching required)
-Measuring range +/- 500 ųm for the 74 mm sensing stylus
-Measuring force applied for the 74 mm sensing stylus
-Deviation in linearity 1% of the measuring range maximum
COMPUTING SYSTEM:
-Evaluation computer: freely programmable computer system with colour graphics
-Screen 14'' colour
-Hard disk 20 MByte
-Floppy disck drive 3,5''
-Output unit: dot-matrix printer (laser printer optional)
DIMENSIONS:
-Height 1720 mm
-Width 1760 mm
-Front-to-back size 815 mm
-Weight 380 kg
USED MATERIAL
KSJ-08L Steel serrated soft jaws to suit a 8 Inch power chuck. Jaws are manufactured from 080M15 Steel.
Good Quality of of material allows for machining with a good finish.
Serial No BO 16077Jones & Shipman 540 surface grinderPower raise & lowerC/w a 460 x 150 mm magnet,( not the one in the photo )Dust extractionlovo light.Calibration : Imp execution.
